01-09-2006, 09:23 AM
Okay I have 3 glow starters and what the cruddy part is this.
I have to take the batteries out of two of them, Solder a connection to them and charge them with my trickle charger. The third one came with a charger pack in an RTR set up.
This takes too long of a process and doing the wall charger would take me 3 days to do all of them.
Does anyone know of where I can get just that end to go into the glow starter?
Then I can put aligator clips on the other end of it.
I would hate to clip this off and retro something to make it work in my applications.
I have to take the batteries out of two of them, Solder a connection to them and charge them with my trickle charger. The third one came with a charger pack in an RTR set up.
This takes too long of a process and doing the wall charger would take me 3 days to do all of them.
Does anyone know of where I can get just that end to go into the glow starter?
Then I can put aligator clips on the other end of it.
I would hate to clip this off and retro something to make it work in my applications.
Life is like Beavers, One Damn thing after another- Unknown
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.