Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rubber shielded or metal shielded?
#1
Im getting new clutch bearings and i was wondering which is better? There both the same price so it doesnt matter:

[PTK-MR105-2RS] ProTek R/C 5x10x4mm rubber sealed "Speed" 1/8 clutch bearings (10)

or

[PTK-MR105ZZ] ProTek R/C 5x10x4mm metal shielded "Speed" 1/8 clutch bearings (10)

Also, are those bearings any good???
Reply
#2
had good luck runnin avids rev. and there disk brakes also
MUGEN SEIKI
GRAVEY GRAFFIX
LEISURE HOURS
Reply
#3
i was thinking about those avids, but how do advantage compare to those? id rather just order all the stuff at once and carolinas or amain doesnt sell avid.
Reply
#4
dont know but once you setup an account its easier than reading chads replys
MUGEN SEIKI
GRAVEY GRAFFIX
LEISURE HOURS
Reply
#5
ya i actually just did. Setting up tyhe accoun twasant the problem, i just didint wanna pay the shipping but its only 2.75 so i decided on the avids. People on truggyracers said there great too.
Reply
#6
Which ones do you guys like? I just ordered a bunch of the revolutions.
Reply
#7
I ran the Revolutions.
Reply
#8
ya i went with the revolutions.
Reply
#9
i like metal shieleded bearing instead fo rubber just beacause you can blow the grease out easier.
Hi im johnny knoxville and welcome to jackass
Reply
#10
get the revolutions they are a dollar a piece. Oh and for the X5T TTR option brakes
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT Confusedalute:
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Reply
#11
ya i was gonna get the brakes but had some other stuff to get. Those and new clutch shoes will be next.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)