Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Starter Box help
#1
Well My Purple Mugen box is no longer working. I'm sure it's not the batteries and it's not the wiring could it be the motors? I recently dropped a screwdriver down by one of the motors and it's not magnetized, I'm thinking this is what caused it and am just wondering if this is the problem what replacement motors I should buy.
Kona Kustom Decals
Pro Twister Mods
Reply
#2
Mikeh had a link to an electronics supply site that sold generic 550 motors for CHEAP....hit him up for that info.
got paint?
Colors by Dave - CBD
1-29-07 ... you know.
Reply
#3
[DYN5611] Dynamite Ready-Start 550 Motor w/Capacitor
those any good?
Kona Kustom Decals
Pro Twister Mods
Reply
#4
y not just get the stock ones if they turn it over fine?
Reply
#5
How much are they though?
Kona Kustom Decals
Pro Twister Mods
Reply
#6
look it up
Reply
#7
I couldn't find it on A-main, B-main or Tower. I'm assuming they're aren't too much more than $20 though.
Kona Kustom Decals
Pro Twister Mods
Reply
#8
Any 550 motor will fit.
8ight | Mini-T | CEN Boat | Stampede | JR R-1

ALL RC STUFF FOR SALE. PM FOR DETAILS.
Reply
#9
Ok so I could buy some cheapo E-maxx motors? Cool beans you can get those for dirt cheap off of ebay.
Kona Kustom Decals
Pro Twister Mods
Reply
#10
I'll sell you my mugen box if it don't work out, $45.
Tekno EB48.4 HobbyWing XR8 Sanwa M12
Reply
#11
Ponch I'll think about it because buying new motors is only saving me $10 compared to yours. I'll let you know.
Kona Kustom Decals
Pro Twister Mods
Reply
#12
make sure the little brass posts are both touching the little middle post when you press it down, may have to take it apart and bend the little tabs in.

GS RACING, TQ FUEL, FASTLANE GRAPHIX, CZECH-IT-OUT
Reply
#13
They are both touching I checked that to make sure it wasn't a contact issue.
Kona Kustom Decals
Pro Twister Mods
Reply
#14
Your switch bad?
8ight | Mini-T | CEN Boat | Stampede | JR R-1

ALL RC STUFF FOR SALE. PM FOR DETAILS.
Reply
#15
There is no switch on Mugen boxes.
Kona Kustom Decals
Pro Twister Mods
Reply
#16
hansarvin Wrote:They are both touching I checked that to make sure it wasn't a contact issue.

did you check to make sure there was no build up on the brass ends?? i know I had this problem becasue dirt got burnt onto the metal to metal contact area and caused an incomplete circuit or w/e
Losi 8ight with v-spec[SIZE="4"]
[/SIZE]
Reply
#17
Well as I was trying to turn the motor over by hand I noticed the cb moved with it. Then I tried to spin it and no luck. Confusedmash: There was a clutch shoe knocked out of place and it was catching. So the box was trying to turn over my motor and the truck. So I charged the batteries last night and am going to see if I can't get it started this morning.
Kona Kustom Decals
Pro Twister Mods
Reply
#18
so you thought your starter box was bad because of a locked up motor in the car? http://www.i dont know what im doing.com
lol
MUGEN SEIKI
GRAVEY GRAFFIX
LEISURE HOURS
Reply
#19
wow....dont u let the starter box come up to speed before bumping your car on it?...
Reply
#20
hey let me know the next time your box is dead and it wont turn over your motor, i can sell you a used ninja.lolol
MUGEN SEIKI
GRAVEY GRAFFIX
LEISURE HOURS
Reply
#21
yea ummm thanks for the offer Al I keep that in mind Rolleyes. Thanks for the help guys, and yes Ryan I do and it works just fine now.

Thanks,
Gary
Kona Kustom Decals
Pro Twister Mods
Reply
#22
wow i figured you at least would have tried getting the flywheel to run w/o the car on it to see if thats your problem....common sense
Losi 8ight with v-spec[SIZE="4"]
[/SIZE]
Reply
#23
hansarvin Wrote:Well as I was trying to turn the motor over by hand I noticed the cb moved with it. Then I tried to spin it and no luck. Confusedmash: There was a clutch shoe knocked out of place and it was catching. So the box was trying to turn over my motor and the truck. So I charged the batteries last night and am going to see if I can't get it started this morning.

Rolleyes
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Just picked up the ofna truggy starter box slaytanic 15 4,357 02-27-2008, 05:44 PM
Last Post: slaytanic
  Mugen Pro Starter Box BII 1/8 Off Road Starter Box Assembly rcrunr1 6 3,457 08-29-2007, 12:53 PM
Last Post: rcrunr1
  Stops after taking off glow starter son1cn 8 3,190 04-21-2007, 10:08 PM
Last Post: Czech-it-Out Graphics
  starter box for X1-CrT pwnzor 11 2,911 02-16-2007, 12:37 AM
Last Post: pwnzor
  Starter Box for X1-CrT pwnzor 0 1,268 02-15-2007, 07:44 AM
Last Post: pwnzor
  revo starter box Meatwad 3 2,021 01-13-2007, 11:19 AM
Last Post: Meatwad
  8ight Starter Box son1cn 27 6,175 01-06-2007, 10:37 PM
Last Post: son1cn
  Best Revo 3.3 Starter box JTak77 9 5,111 01-06-2007, 07:01 PM
Last Post: son1cn
  Can I run with out a starter on? Ponch 2 1,370 05-19-2006, 10:47 AM
Last Post: Ponch
  Need A Recomendation For A Starter GWPHOENIX 5 2,499 03-28-2006, 08:06 PM
Last Post: Traxxas_Junkee

Forum Jump:


Users browsing this thread: 2 Guest(s)