Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Stadium Truck Requirments
#1
Hey i'm going to race my Jato 3.3 this winter a LHR at the indoor dirt track but i need to know what is the engine size requirement? I'd love to run my Modded 3.3 there, and is there any other requirements? Thanks.
-Pete
Reply
#2
The question will be what class do you hope to run in, because 1:10 GT doesn't allow the 2sp transmission.
Reply
#3
Well i've never raced there before so i have no clue. All i know is i want to race on the dirt track inside.
-Pete
Reply
#4
SEEKandDESTROY2 Wrote:Well i've never raced there before so i have no clue. All i know is i want to race on the dirt track inside.
-Pete

It's clay indoors.
Reply
#5
UE-Maxx Wrote:It's clay indoors.
Alright lol, close enough. Either way i heard its amazing.
-Pete
Reply
#6
I think they will alow any motor but ROAR rules are .12 with a single speed tanny. But they might allow .15 i am not sure
Reply
#7
As long as the .20 isn't giving you a definate, noticealbe advantage over the other trucks, it'll be fine. Also, you should take the 2 speed out, keep it single.
Tekno EB48.4 HobbyWing XR8 Sanwa M12
Reply
#8
Yeah, 65mph on the backstraight won't be an advantage...unless you have an anchor for brakes.

Maybe you can just screw down the shift point so it stays in first?
got paint?
Colors by Dave - CBD
1-29-07 ... you know.
Reply
#9
DAVEC-NITRO-RS4 Wrote:Yeah, 65mph on the backstraight won't be an advantage...unless you have an anchor for brakes.

Maybe you can just screw down the shift point so it stays in first?


That would suck...He'd go nowhere and probably blow the motor.

I would get the single speed...it's in the middle of a 1st and 2nd gear basically as far as teeth.
Tekno EB48.4 HobbyWing XR8 Sanwa M12
Reply
#10
The 3.3 would have to go. When I had a 2.5 Jato all I heard was that you couldn't race it. Its too fast even without the 2spd transmission.

Not only that, but the 3.3 woud make it hell to control on the track. Any time you burped the throttle you'd either lift the front tires or lose the rear end. I ran my Jato on the indoor track and the acceloration was phenominal. The only place I could get on it was the back straight.

And on the out door track? Forget it. You'd never be able to keep it straight at anything more than half throttle.
Reply
#11
Well I ran a Losi ad2. All last winter...or since they opened and have only seen a few jatos on the track. If your running the club races, bring it on any way you can get it there. No one would care if you put a .21 and a 6 speed in that thing. Just bring it....

MBX5T - O.S.
MBX5R - Novarossi
Nomadio
Reply
#12
MX_KEVIN Wrote:Well I ran a Losi ad2. All last winter...or since they opened and have only seen a few jatos on the track. If your running the club races, bring it on any way you can get it there. No one would care if you put a .21 and a 6 speed in that thing. Just bring it....

That'd be sweet...Schumacher hits 70...x3=210 MPH!!!
Tekno EB48.4 HobbyWing XR8 Sanwa M12
Reply
#13
MX_KEVIN Wrote:Just bring it....
Thats what i think i'm gona do. I hope they don't mind the second speed. I have very good throttle control with that truck, so watch out lol.
-Pete
Reply
#14
They won't mind for club racing, bigger races you may want to get it legal but everyday racing is ok with your 3.3 and 2speed
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#15
Sweet, i picked up my tires for racing there today. Got a set of M3 Bowties and M3 Edges, with some Proline agitator rims. Gona look sweet.
-Pete
Reply
#16
Those street treads might do well indoors, as well.
got paint?
Colors by Dave - CBD
1-29-07 ... you know.
Reply
#17
DAVEC-NITRO-RS4 Wrote:Those street treads might do well indoors, as well.
Really? On the dirt track?
-Petee
Reply
#18
Indoor track is clay and even bald tires can get traction inside. Outdoor track? Ouch with bald tires.
Reply
#19
indoor has as much traction as the street (dang near if not the same)
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#20
So much so that slicks are banned for indoor racing! (correct me if I said that wrong). Some days it will be slick if the water doesn't soak in. Then you will need to experiment with treads.
got paint?
Colors by Dave - CBD
1-29-07 ... you know.
Reply
#21
Well i got a set of bowties and edges so i think i'll be good with traction. Can't wait to race. Anyone know what days i can go and practice there?
-Pete
Reply
#22
Tuesdays, Thursdays, and Saturdays, then racing on Sunday for Nitros
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#23
slicks are not banned. It's to hard to say what is slick. During a race day slicks are only good for practice and maybe 1st round of qualifying. After that you'll need a pin on the tire.

mikeL
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Losi Desert Truck Astro 18 10,212 01-29-2009, 04:43 AM
Last Post: GeraldRisch
  19 turn truck? jhautz 7 5,705 11-11-2008, 11:37 AM
Last Post: Rob Kass
  Mini Truggy and 1/10th gas truck Racing Wed. 3-12-08 Rob Kass 4 2,766 03-19-2008, 09:28 PM
Last Post: motoxer4life
  Monster truck racin? bubbaracing 42 10,213 01-24-2007, 01:53 AM
Last Post: Czech-it-Out Graphics
  Stadium Class SEEKandDESTROY2 17 4,202 12-31-2006, 12:22 AM
Last Post: Czech-it-Out Graphics

Forum Jump:


Users browsing this thread: 1 Guest(s)